![]() ![]() All vehicles should be parked on the same side to avoid cluttering up the street. ![]() Upon arriving at the work area, the truck shall be legally parked, with the parking brake applied, until the appropriate vehicle and pedestrian warning signs, lights and barricades have been set up. Improper vehicle setups have caused lower booms to be struck by trucks, causing serious damage and even employee fatalities. Traffic control should be set up according to the Manual on Uniform Traffic Control Devices to channel traffic away from the work area. When working distribution on roads and highways, the lower boom should be in the clear of traffic. Before an employee enters the work platform or bucket, a test of the lower bucket controls is required to ensure they are operational in case an emergency rescue is needed.ĭepending on the size of the bucket truck, select a proper distance from the structure to assure the lower boom is in an elevated position of 45 degrees or greater to ground. Once on the job site, and before raising the boom and bucket, inspect all critical lifting components and properly set up for the work to be done. Proper storage of the tools prevents damage to the bucket and stops them from potentially falling out of the bucket and creating a hazard to pedestrians and the driving public. Tools should be removed from the bucket during highway travel unless they are properly secured. The mobile operation can be accomplished safely while observing overhead structures, obstructions, adverse ground surface conditions and congestion, including public traffic.Repositioning is allowed only for short distances when it is required to accomplish the work.The aerial bucket is returned to the stored position.However, it is permissible for the bucket to be occupied during certain mobile operations on the work site provided that the following occurs: In general, riding in the bucket is not permitted by aerial device manufacturers. A tool bag should be made available for this purpose. If the jib is removed from the bracket to be stored, it must be stored in a manner that will not compromise the dielectric properties or structural integrity of the jib. The material-handling jib can be retained in the jib bracket and stored in the retracted and horizontal position (against the jib stop) prior to travel. The aerial bucket should be in the stored position anytime the vehicle is in motion. Any aerial device that contacts a fixed object while the truck is moving should be thoroughly inspected by fleet personnel prior to being used again as an aerial lift. Operators also must be properly trained before getting behind the wheel.ĭrivers of insulated aerial bucket equipment must be constantly alert to the fact that the vehicle has exposed equipment above the elevation of the truck cab, and they must make certain that safe roadway clearances are available. Most of the trucks, if not all of them, require the operator to possess a commercial driver’s license. Department of Transportation’s requirements to drive a bucket truck. It’s critical for every company to have documentation that sets expectations for all employees about the safe and proper use of bucket trucks.įirst, let’s look at the U.S. I have performed fields audits for many companies over the years, and I want to share some facts about operational safety and proper use of insulated aerial devices. Manufacturing performance standards for insulated aerial devices can be found at ANSI A92.2 and OSHA. The trucks are the most reliable when all of the manufacturer’s recommendations are followed and routine maintenance is performed. In the electric utility industry, we use bucket trucks – often referred to as insulated aerial devices – to help maintain and improve productivity and safety. Many industries use bucket trucks to help workers accomplish tasks. ![]()
0 Comments
Leave a Reply. |